Vacuum Pump, Removing And Installing, Vehicle With 3.0L TFSI Engine: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Clean bolts before reusing.
Replace damaged bolts.
Always replace self-locking bolts.

-- Position the vacuum pump driver -1- so it engages in the symmetrical groove on the camshaft when positioning -arrows-.

Fig 1: Position Vacuum Pump Yoke

Courtesy of AUDI OF AMERICA, LLC

-- Push the new hose clamp over the vacuum hose.

-- Install the vacuum hose with the hose clamp -1- connected.

Fig 2: Locating Hose Clamp -1-

Courtesy of AUDI OF AMERICA, LLC

-- Install the engine cover. Refer to ENGINE COVER .