Vacuum Pump, Removing And Installing, 2.0L TFSI Engine: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Replace the seal after removal.
- Check the vacuum lines for damage before assembling and replace if necessary.
- Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
-- Turn the vacuum pump yoke -1- so it engages in the groove on the camshaft when positioning the vacuum pump in direction of -arrows-.
-- Install the vacuum hose with the hose clamp -1- connected.
-- Tighten the bolts -arrows-.
-- Install the high pressure pump. Refer to HIGH PRESSURE PUMP - 2.0L .