Brake Caliper Piston, Removing And Installing: Installing

Fig 1: Identifying Protective Seal With Outer Sealing Lip On Piston

Courtesy of AUDI OF AMERICA, LLC

-- Thinly coat the brake caliper piston and the gasket with Lithium Grease: G 052 150 A2  before installing.

-- Insert the gasket into the brake caliper.

-- Place the protective cap with outer sealing lip on the brake caliper piston.

-- Turn the thrust nut far enough onto the spindle so that the dimension -a- = 15 mm is reached.

Courtesy of AUDI OF AMERICA, LLC

-- Insert the inner sealing lip of the protective cap into the groove -arrows- in the brake caliper using the : 3409  .

Fig 2: Identifying Inner Sealing Lip Of Protective Boot Inserted In Groove In Brake Caliper With Trim Removal Wedge 3409

Courtesy of AUDI OF AMERICA, LLC

-- Slide the brake caliper piston -1- onto the thrust nut, which is only possible in four positions.

-- Carefully press the brake caliper piston into the brake caliper by moving the brake caliper piston.

-- Press the brake caliper piston far enough into the brake caliper until it touches the thrust nut.

Fig 3: Pressing Piston Into Brake Caliper Until It Contacts Pressure Nut

Courtesy of AUDI OF AMERICA, LLC

-- Carefully turn the spindle clockwise in direction of -arrow upper- until the thrust nut is at the stop.

Fig 4: Identifying Pressure Nut Clockwise

Courtesy of AUDI OF AMERICA, LLC

• The protective cap must fully contact the brake caliper -arrows-.
  Fig 5: Ensuring Protective Cap Is Seated Against Brake Caliper Housing

  Courtesy of AUDI OF AMERICA, LLC

-- Press the brake caliper piston into the brake caliper by hand.

Fig 6: Pressing Piston Into Brake Caliper

Courtesy of AUDI OF AMERICA, LLC

• Outer sealing lip of protective cap will then engage in the brake caliper piston groove.