BLEEDING WITH ABS Hydraulic Unit -N55- PUMP

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

If the Brake System Cannot Be Bled Correctly, Proceed as Follows:

NOTE:

The hydraulic pump must be activated by the interchange test.

-- Bleed the hydraulic system. Refer to HYDRAULIC SYSTEM, BLEEDING WITH BRAKE CHARGER/BLEEDING UNIT .

Also:

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Fill the brake fluid reservoir up to the "MAX" mark.

Fig 1: Brake Fluid Reservoir

Courtesy of AUDI OF AMERICA, LLC

-- Select and start OBD mode.

-- Select 003- Brake electronics .

-- Select the basic setting button.

-- Bleed the brakes. Refer to HYDRAULIC SYSTEM, BLEEDING WITH BRAKE CHARGER/BLEEDING UNIT .

-- Use login 40168.