Actuator Pin Information
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
The actuator pin -15- must always be pushed in the hole in the brake master cylinder directly on the Brake Lamp Switch -F-.
If the actuator pin is missing, damaged or bent, then the Brake Lamp Switch -F- will not function.
The actuator pin cannot be replaced separately.
NOTE:
The brake lamp function must be checked after installing the brake master cylinder.