Charge Air Pressure Actuator -V465-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
Step for A4, A5, Q5, A6 and A7:
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
All:
-- Disconnect the connector -4-.
-- Loosen the lock nut -2- a quarter turn, to do so counterhold on the control rod hex fitting -arrow-.
-- Remove the control rod from the operating lever -1- at the same time do not turn the lock nut.
-- Remove the bolts -3- and then the Charge Air Pressure Actuator -V465-.