Lumbar Support Adjustment Motors -V125- / -V126- / -V129- / -V130-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Secure the front seat to the :VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .

-- Remove the backrest seat cover and cushion. Refer to BACKREST COVER AND CUSHION, REMOVING AND INSTALLING, SEAT WITHOUT PNEUMATIC COMPONENTS .

-- Release and disconnect the connectors -1 and 2- at the lumbar support forward/back and height adjustment motors.

Courtesy of AUDI OF AMERICA, LLC

-- Cut through the cable tie and free up the wiring harness on the lumbar support.

CAUTION:

Risk of injury due to flying metal shavings.

Irritation and injury to skin and eyes possible.

- Wear protective eyewear.

- Wear safety gloves.

-- Drill out the rivet -3-.

-- Move the lower lumbar support -1- forward, pivot it out of the backrest frame, disengage it at the top of the backrest frame -2- -arrows- and remove it.

Courtesy of AUDI OF AMERICA, LLC