Seat Pan Cover And Cushion, Removing And Installing, Seat Without Seat Depth Adjuster: Removing

WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Secure the front seat to the : VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .

-- Remove the tunnel-side seat side trim. Refer to SEAT SIDE TRIM ON TUNNEL SIDE, REMOVING AND INSTALLING .

-- Remove the seat side trim on the side sill side and remove the bracket. Refer to SEAT SIDE TRIM ON SIDE SILL SIDE, REMOVING AND INSTALLING .

-- Remove the backrest. Refer to FRONT BACKREST, REMOVING AND INSTALLING .

-- Equipped on some models: remove the child seat anchor. Refer to FRONT CHILD SEAT ANCHOR, REMOVING AND INSTALLING .

-- Versions: observe the notes for the passenger occupant detection system. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .

-- Release, disconnect and free up the connectors. Refer to MODULAR WIRING ROUTING, DISCONNECTING AND CONNECTING .

-- Detach the molding -1, 2 and 7- of the seat cover in the front and side areas using the : 3370 .

Fig 1: Identifying Lower Seat Frame Cover And Cushion Components

Courtesy of AUDI OF AMERICA, LLC

-- Detach seat cover molding -5- in the rear area using the : 3370 .

-- Disengage the left and right tab hooks -4, 6- on the seat pan -3-.

-- Remove the seat cover and seat cushion -8- from the seat pan while guiding the seat heating wiring harness.