Front Three-Point Seat Belt, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- If parts of the seat belt system are removed due to an accident, replace the belt system bolts.
- Make sure the connectors are pushed in all the way and that they engage audibly.
- After replacing the Left Front Seat Belt Tensioner Control Module -J854- /Right Front Seat Belt Tensioner Control Module -J855- the control module must be coded using the Vehicle Diagnostic Tester.
-- Insert the automatic belt retractor with the anti-twist mechanism -1- in the mount -arrow- and tighten the bolt.
Further installation is the reverse order of removal.
CAUTION:
Risk of airbag deployment.
There is a risk of injury.
- Switching on the ignition (key/button) after assembly may only be done when the driver seat is positioned all the way back.
-- Check and erase the airbag control module DTC memory because faults can be stored from when the connectors are disconnected. Use the Vehicle Diagnostic Tester.