Closing Assist Release Cable, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear lid lower trim panel and the latch cover. Refer to REAR LID LOWER TRIM PANEL, REMOVING AND INSTALLING .
-- Turn the operating cable on the lever -3- 90° in the -direction of arrow A- and remove it from the cable bracket -2-.
-- Using a screwdriver -1-, secure the operating lever -5- on the opposite side -arrow B-.
-- Disengage the cable nipple -4- on the operating lever -arrow C-.
-- Disengage the cable bracket -4- on the Rear Lid Closing Assist Motor - V382- to do so release the catches -arrows-.
-- Disengage the cable nipple -3- from the operating cable -2-.
-- Remove the cable -1-.