Terminal 30 Wire Junction 2 -TV22-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .

On vehicles with 48 volt system (PR number VH2/VH3) the 48 V system must first be de-energized. Refer to 48V SYSTEM, DE-ENERGIZING .

-- Release the retainers in direction of -arrows-.

-- Open the cover in the sequence -2 and 1-.

-- Remove the wires -2 to 5- and free them up.

Fig 1: Digital Sound System Control Module Connector End View (J525, T38, T18i, T2ca)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -6-.

-- Release the retainers in direction of -arrows- and remove the wire junction -1-.