Terminal 30 Wire Junction -TV2-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .
- On vehicles with 48 volt system (PR number VH2/VH3) the 48 V system must first be de-energized. Refer to 48V SYSTEM, DE-ENERGIZING .
-- Remove the terminal 30 wire junction 2 and move to the side with the lines still connected. Refer to Terminal 30 Wire Junction 2 -TV22-, REMOVING AND INSTALLING .
-- Disconnect the connector -4-.
-- Remove the nuts -3 and 5- and free up the wires -2 and 6-.
-- Remove the nuts -arrows-.
-- Remove the wire junction -1- from the threaded pins.