Main Fuse Panel On Battery, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Battery Ground Cable Connector With Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .

On vehicles with 48 volt system (PR number VH2/VH3) the 48 V system must first be de-energized. Refer to 48V SYSTEM, DE-ENERGIZING .

-- Open the cover -1- over the battery positive terminal.

-- Loosen the nut -3- several turns and remove the battery positive cable terminal clamp -2- from the battery terminal.

-- Release the catch -3- and open the flap -2- above the main fuse panel -1- in direction of -arrow-.

Fig 2: Fuse Box Cover, Removal

Courtesy of AUDI OF AMERICA, LLC

-- Remove the wires -1, 2, 4, 5, and 6-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the main fuse panel -3-.