Data Bus on Board Diagnostic Interface -J533-, REMOVING AND INSTALLING, LOW VERSION: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
The Data Bus on Board Diagnostic Interface -J533- is located under the left front seat.
-- Remove the left front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Lift the front carpet at the transition to the rear carpet.
-- Release the catch -2- and remove the mount -3- from the threaded pin -1-.
-- Guide out the mount from the body -arrow-.
-- Release the retainers in direction of -arrows-.
-- Remove the data bus on board diagnostic interface -3- from the mount -2-.
-- Disconnect the connector -1-.