Right Bulkhead Connector Station, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the carpet on the front passenger side. Refer to CARPET, REMOVING AND INSTALLING .
-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Disconnect the connectors -1 and 2- by sliding the retainer toward the rear and pressing the release downward.
-- Remove the connector station -3- from the threaded pin.
-- Release the retainer -3- in direction of -arrow- and push the connector terminal -2- out of the bracket -1-.