Cam Adjustment Actuator, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Check the O-rings for damage
The cam adjustment actuator pin must be brought into the installation position.

Fig 1: Bring the Cam Adjustment Actuators into the Installed Position
Courtesy of AUDI OF AMERICA, LLC

-- Press down the cam adjustment actuator pin in direction of -arrow- by hand.

The adjusting element pin must not be in the outward position.

-- Coat the O-rings with engine oil.

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

Additional procedures depending on the model. Refer to CAM ADJUSTMENT ACTUATOR, REMOVING AND INSTALLING .