Door, Removing And Installing
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2022 Audi RS 7 Sportback, 2022 Audi A7 e Quattro, 2022 Audi A7 Quattro, 2021 Audi S7, and 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- To complete the procedure, a second technician is required to be at the following position found here. Refer to DOOR, REMOVING AND INSTALLING => Carefully remove the door upward out of the hinges. .
Removing
-- Disconnect the door cut-off connector -1- from the A-pillar. Refer to Connectors .
-- Tape off the A-pillar in the door arrester area using adhesive tape, so that the paint will not be damaged.
-- Remove the door arrester bolt -2-.
-- Remove the upper and lower cap -4-.
-- Remove the set screw -3- from the upper and lower hinge.
-- Carefully remove the door upward out of the hinges.
Installing
Install in reverse order of removal and note the following:
- Do not make any adjustments after installing the front door.
Tightening Specifications
- Refer to OVERVIEW - DOOR