Decoupler Actuator -V606-, REMOVING AND INSTALLING: Installing
Install in reverse order of removal and note the following:
-- Clean the sealing surface to the actuator.
-- Secure the driver -2- with a suitable quantity of grease on the Decoupler Actuator -V606- -1- and position so that when positioning the symmetrical spring engages in the decoupler -arrow-.
-- Install the steering intermediate shaft. Refer to STEERING COLUMN .
-- If the Decoupler Actuator -V606- was replaced, then the Decoupler Actuator -V606- must be adapted and the service mode must be deactivated.
Decoupler Actuator -V606-, Adapting
The Vehicle Diagnostic Tester is connected.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Drivetrain
- Engine code
- 01 - OBD-capable systems
- 01 - Engine Control Module J623
- 01 - Engine electronics, functions
- J623 - Engine/Motor Control Module Function
Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
Service, Deactivating
The Vehicle Diagnostic Tester is connected.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Drivetrain
- Engine code
- 01 - OBD-capable systems
- 01 - Engine Control Module J623
- 01 - Engine electronics, functions
- 01 - Activate/deactivate the service mode
Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.