Front Axle Toe, Adjusting

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

-- Measure the dimension -a- between the tie rod head -1- and the left and right tie rod -2-. Note the value. Dimension -a- should be the same before and after adjusting on the left and right.

Fig 1: Measuring Tie Rod Head / Tie Rod Dimension

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the lock nut -B- by counterholding the tie rod end -C-.

Fig 2: Locating Lock Nut

Courtesy of AUDI OF AMERICA, LLC

-- Adjust the toe respectively at the left and right wheel with the hex fitting -A-.

CAUTION:

There is a risk of premature wear if the boot is twisted.

- Make sure the boot is not twisted when it is installed.

-- Tighten the lock nut -B-, List Item: Nut and check toe-in value again.

TIP:

After tightening the lock nut -B-, it is possible that the value will deviate slightly.
However, if the measured toe value lies within the tolerance, the adjustment is correct.