Component Overview - Alloy Wheel

WARNING: This page is about a different car, the 2021 Audi SQ7, 2021 Audi Q7, 2020 Audi SQ7, and 2020 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Alloy Wheels

Courtesy of AUDI OF AMERICA, LLC

Tires
CAUTION:
The minimum mounting temperature for a tire may not be below 21°C or above 30°C (13 °F or above 19 °F).
Valve
- Always replace.
- Refer to the Parts Information for the allocation of the only valves to be installed.
  CAUTION:
  Do not screw any aluminum valve caps onto steel valve bodies. Aluminum caps attach to the steel valve body into a inseperable connection and cannot be separated again.
Wheel
- Note the assembly instructions.
Wheel Bolt
- Anti-theft wheel bolts.
Wheel Bolt Adapter
- Attach to the wheel bolt intended for it.
Cap for Wheel Bolts
NOTE:
After achieving and checking the correct torque on "all wheel bolts", install the caps completely on the wheel bolts.

Use the back of a screwdriver or a suitable tool to do this. Do not damage the cap.
Cap
Wheel Bolt
NOTE:
Make sure the correct wheel bolts are installed. Refer to Parts Information.
Adhesive Balancing Weights
- Maximum 60 grams per rim flange permitted
- Clean wheel where it will be adhered so it is free of dirt and grease
- Remove protective film.
- Attach balance weights to intended surfaces.