Drip Rail, Removing And Installing
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2022 Audi RS 7 Sportback, 2022 Audi A7 e Quattro, 2022 Audi A7 Quattro, 2021 Audi S7, and 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Hand drill
- 5 mm drill bit
Drip Rail, Removing:
-- Starting at the bottom, remove the drip rail -1- upward -arrow-.
Drip Rail Clamping Strip, Removing:
-- Drill out the rivet heads -arrows- and drive out the rivet shafts.
-- Remove the clamping strip -1-.
Installing
Install in reverse order of removal and note the following:
-- Starting at the top, insert the drip rail -2- into the clamping strip. The raised section -3- must engage in the cut-out while doing so -arrow-.
-- Press the drip rail all the way into the clamping strip.