Overview - Coolant Pump/Coolant Thermostat
WARNING: This page is about a different car, the 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- Map Controlled Engine Cooling Thermostat -F265-
- Removing and installing. Refer to Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Bolt
- Tightening specification and sequence. Refer to Fig 3.
- Right Front Coolant Pipe
- Equipped on some models
- Bolt
- Tightening specification. Refer to OVERVIEW - COOLANT PIPES .
- For ) OVERVIEW - COOLANT PUMP/COOLANT THERMOSTAT
- O-Ring
- Replace after removing.
- For ) OVERVIEW - COOLANT PUMP/COOLANT THERMOSTAT
- Seal
- Replace after removing.
- Connection
- Replace after removing.
- Bleeder Line
- Bolt
- 9 Nm
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- Coolant Pump
- Removing and installing. Refer to COOLANT PUMP, REMOVING AND INSTALLING .
- Vacuum Hose
- Gasket
- Replace after removing.
- Oil Pressure Sensor -G10-
- Overview. Refer to OVERVIEW - OIL PRESSURE SWITCH/OIL PRESSURE REGULATION .
- O-Ring
- Replace after removing.
- O-Ring
- Replace after removing.
- Seal
- Replace after removing.
- Housing for the Map Controlled Engine Cooling Thermostat -F265-
- There are different versions.
- Removing and Installing. Refer to HOUSING FOR Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING .
- Seal
- Replace the Map Controlled Engine Cooling Thermostat -F265- after removing
- O-Ring
- Replace after removing.
Coolant Pump - Tightening Specifications and Sequence
-- Tighten the bolts -1 to 7- in stages as follows:
| Step | Tightening Specification |
|---|---|
| 1. | Install by hand all the way |
| 2. | 5 Nm |
| 3. | 9 Nm |
Housing for the Map Controlled Engine Cooling Thermostat - F265 - Tightening Specification and Sequence
Fig 3: Housing for the Map Controlled Engine Cooling Thermostat -F265- - Tightening Specification and Sequence
-- Tighten the bolts -1 to 9- is stages as shown.
| Step | Tightening Specification |
|---|---|
| 1. | Install by hand all the way |
| 2. | 9 Nm |