Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Replace the gasket and O-ring after removal.
-- Push on the seal -arrow- using the Thrust Piece:T40357 and drive in all the way.
- The open side of seal faces the engine.
-- Install the housing for the Map Controlled Engine Cooling Thermostat -F265-. Refer to HOUSING FOR Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING .