HOUSING FOR Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work may be required depending on the model. Refer to HOUSING FOR Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING
-- Remove the oil dipstick tube -item 7- OVERVIEW - BELT PULLEY SIDE SEALING FLANGE => List Item:Oil Dipstick Tube .
-- Place the :VAS6208 underneath.
Fig 1: Housing for the Map Controlled Engine Cooling Thermostat -F265- - Tightening Specification and Sequence
-- Remove the bolts -1 to 9- and remove the housing for Map Controlled Engine Cooling Thermostat -F265-. (Shown on Audi A8 / S8.)