Overview - Exhaust Manifold
WARNING: This page is about a different car, the 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- Seal
- Replace after removing.
- Exhaust Manifold
- Removing and installing. Refer to EXHAUST MANIFOLD, REMOVING AND INSTALLING .
- Retaining Plate
- Nut
- Tightening specification and sequence. Refer to Fig 1.
- Replace after removing.
- Alignment Pin
- Seal
- Replace after removing.
Exhaust Manifold - Tightening Specification and Sequence
- Replace the nuts after removing.
-- Tighten the nuts -1 to 8- is stages as shown.
| Step | Tightening Specification |
|---|---|
| 1. | Install by hand all the way |
| 2. | 20 Nm |
| 3. | 27 Nm |