Cam Actuator, Removing And Installing: Installing
WARNING: This page is about a different car, the 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Check the O-ring for damage.
-- Bring the cam actuator pin into the installation position.
- The cam actuator pin must be pushed in completely in direction of -arrows-.
-- Place the cam actuator in the guide in the camshaft housing align and press it on until the O-ring aligns.
-- Slowly press again until the cam actuator makes full contact.
TIP:
If pressed in quickly a pin can unintentionally move.
CAUTION:
Risk of damaging the camshaft housing by tilting the cam actuator.
- Never insert the cam actuator with the bolts in the camshaft housing.
Additional procedures depending on the model. Refer to CAM ACTUATOR, REMOVING AND INSTALLING .