Drive Plate, Removing And Installing: Installing

WARNING: This page is about a different car, the 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

If the drive plate was removed or replaced, the sensor wheel function must be checked before installation. Refer to SENSOR WHEEL, CHECKING .
Replace the bolts that were tightened with an additional turn after removing them.

-- Pay attention to the alignment pin when installing the drive plate.

-- Reposition the :10-201 to tighten the bolts.

After removing and installing or replacing the engine, perform the adaptations listed in the guided function "0001 - mechanical engine, functions" using the Vehicle Diagnostic Tester.