Vibration Damper, Removing And Installing: Removing
WARNING: This page is about a different car, the 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Depending on the model, preliminary work may be required. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
-- Remove the ribbed belt for the starter generator. Refer to STARTER GENERATOR RIBBED BELT, REMOVING AND INSTALLING .
-- Remove the cover.
-- Remove the bolt -arrow- and the idler roller.
-- Place the :T40330/5 with :T40330/1 on the vibration damper and secure using the M8x35 bolt -arrow- ; from the : T40330 (23 Nm), to do so, place the :T40330/3 underneath.
-- Remove the bolt -1-.
-- Remove the bolt -arrow- and remove the Counter Holder and vibration damper.