LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> S7 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Crankshaft, Cylinder Block [CXYA,CWWB,DJPB,DCUE,DHUB]) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Ribbed Belt, Removing And Installing >> Starter Generator Ribbed Belt, Removing And Installing >> Installing

Starter Generator Ribbed Belt, Removing And Installing: Installing

WARNING: This page is about a different car, the 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

-- Install the ribbed belt. Refer to Figure.

-- To tension the ribbed belt release the tensioner.

-- Check whether the ribbed belt is routed correctly.

-- Install the A/C compressor ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Start the engine and check the ribbed belt routing.

There are different procedures depending on the model. Refer to RIBBED BELT, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals