Crankshaft, Removing And Installing: Notes
WARNING: This page is about a different car, the 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Puller - Unit Injector:T10055
- Torx Screw Driver - T25:T10248
- Locking Pin (3 pc.):T40011
- Extracting Tool: T40332
- Locking Tool:T40362
- Puller - Unit Injector:T10055
- Torx Screw Driver - T25:T10248
- Locking Pin (3 pc.):T40011
- Extracting Tool: T40332
- Locking Tool:T40362
Puller :T40332 Preparing
-- Tighten the pull rod -1- with the bolts -arrows- as shown on the :T40332 .
-- Remove the threaded pins -2- for later assembly of the tool.