Headlamp Housing, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2022 Audi RS 7 Sportback, 2022 Audi A7 e Quattro, 2022 Audi A7 Quattro, 2021 Audi S7, and 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Check all of the adjusters -2- on the headlamp. To do so, the adjusting nut -1- must be gently screwed on -arrows-.
-- Rotate the adjusting nut all the way down but do not tighten it.
-- Align the headlamp with the fender edge.
- The headlamp must be flush with the fender.
TIP:
Tightening the bolt automatically turns the adjusting nut on the adjuster against the headlamp housing mounting point and secures the housing.
-- Adjust the headlamp. Refer to HEADLAMP, ADJUSTING .