LEFT SEAL, REPLACING, 0D3 "quattro sport" AND 0BX "quattro sport": Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- Follow all general repair information. Refer to REPAIR INFORMATION .
-- Remove the rear final drive. Refer to FINAL DRIVE, REMOVING AND INSTALLING .
-- Remove the flange shaft bolt. To do this, install two bolts into the flange and counterhold the flange shaft using an assembly lever.
-- Remove the flange shaft.
Tip:
- If it is not possible to remove the flange shaft by hand, then use the Slide Hammer Set VW 771 to remove it.
-- Remove flange shaft seal with the Slide Hammer Set : VW 771 and Slide Hammer Set - Pulling Hook : VW 771/37 .