LEFT SEAL, REPLACING, 0D3 "quattro sport" AND 0BX "quattro sport": Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
Install the right shaft seal.
-- Coat the outer circumference and the sealing lips on the shaft seal with ATF.
-- Install the shaft seal all the way. Be careful not to bend it.
Installing the left shaft seal
-- Coat the outer circumference and the sealing lips on the shaft seal with ATF.
-- Install the shaft seal all the way. Be careful not to bend it.
-- Insert the flange shaft.
Tip:
- If it is not possible to install the flange shaft all the way in by hand, then use a plastic mallet.
-- Tighten the new flange shaft bolt to the tightening specification -item : Bolt.
-- Install the rear final drive. Refer to FINAL DRIVE, REMOVING AND INSTALLING .
-- Check the ATF level in the rear final drive. Refer to ATF LEVEL, CHECKING .