INPUT SHAFT SEAL, REPLACING, 0DB, 0D2, 0G2, 09R "quattro ultra", 0B0 "quattro ultra": Removing

• The rear final drive is removed.
• Pay attention to the general repair information. Refer to REPAIR INFORMATION .

-- Place the vehicle on a hoist.

Audi Q7 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the center underbody trim panel. Refer to UNDERBODY TRIM PANELS, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and the crossmember -1-.

Courtesy of AUDI OF AMERICA, LLC

Fig 1: Clamping Sleeve Threaded Connections

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the lock washer(s) -arrows- and separate the exhaust system.

-- Tie up the front exhaust pipe(s) on the side to the underbody.

Audi A4 and A5 

-- Remove the rear section of the exhaust system. Refer to the appropriate Exhaust Information .

Continuation for all vehicles 

Fig 2: Install the driveshaft on the rear final drive.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the driveshaft on the rear final drive. Refer to DRIVE SHAFT, REMOVING FROM REAR FINAL DRIVE AND INSTALLING .

-- Tie the driveshaft to the side.

-- Remove the High Temperature Grease in the flange/driveshaft.

Fig 3: Identifying Circlip, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Remove the circlip -arrow-.

• Replace the circlip with a new one of the same thickness if it is stretched or damaged. Refer to the Parts Information for the allocation.

-- Mark the position of the flange/driveshaft -B- on the pinion -A- -arrow-.

Fig 4: Locating Mark Position Of Flange/Driveshaft To Pinion

Courtesy of AUDI OF AMERICA, LLC

• This marking -arrow- is needed so the colored dot -C- on the outer flange remains in its original position.
• This ensures the imbalance in the rear final drive will be as small as possible.

-- Secure the Puller - Multiple Use: VW 391  with Two M 8 x 30 Bolts -arrow- on the flange/driveshaft.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the flange/driveshaft using the Puller - Multiple Use: VW 391  .

-- Place the Used Oil Collection and Extraction Unit: SMN372500  underneath.

Fig 5: Puncturing Metal Cover Using Scriber

Courtesy of AUDI OF AMERICA, LLC

-- Knock through the metal ledge of the shaft seal -A-, for example, with a scriber -B- in the -direction of the arrow-.

-- Then install a bolt -arrow- in this shaft seal opening -A-.

Fig 6: Identifying Screw On Metal Cover

Courtesy of AUDI OF AMERICA, LLC

-- Remove the shaft seal -A- for the flange/driveshaft over the bolt -B- in the -direction of the arrow-.

Fig 7: Identifying Flange/ Driveshaft Seal, Removal

Courtesy of AUDI OF AMERICA, LLC