INPUT SHAFT SEAL, REPLACING, 0DB, 0D2, 0G2, 09R "quattro ultra", 0B0 "quattro ultra": Notes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Puller - Multiple Use: VW 391

Fig 1: Puller - Multiple Use VW391
Courtesy of AUDI OF AMERICA, LLC
Slide Hammer Set - Adapter 40: VW 771/40 from the Slide Hammer Set: VW 771

Fig 2: Identifying Slide Hammer Set
Courtesy of AUDI OF AMERICA, LLC
Puller - Unit Injector: T10055

Fig 3: Identifying Puller T10055
Courtesy of AUDI OF AMERICA, LLC
Seal Installer - Hollow Shaft: T10380

Fig 4: Identifying Thrust Piece - T10380-
Courtesy of AUDI OF AMERICA, LLC
-2- Puller - Unit Injector - Adapter 2: T10055/2
Guide Sleeve: T40222/1

Fig 5: Assembly Tool T40222
Courtesy of AUDI OF AMERICA, LLC
Inductive Heater: VAS 6414

Fig 6: Identifying Inductive Heater VAS 6414
Courtesy of AUDI OF AMERICA, LLC
or
Commercially Available Hotplate with Digital Thermometer: VAS 6519

Fig 7: Identifying Digital Thermometer VAS 6519
Courtesy of AUDI OF AMERICA, LLC
Used Oil Collection and Extraction Unit: SMN372500

Fig 8: Identifying Used Oil Collection And Extraction Unit
Courtesy of AUDI OF AMERICA, LLC
Sealing Grease: G 052 128 A1
Two M 8 x 30 Bolts