All-Wheel Drive Pump -V415-, REMOVING AND INSTALLING, 0D3 AND 0BX: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
-- Place the vehicle on a hoist.
- The ignition is off.
-- Place the Drip Tray under the rear final drive.
-- Disconnect the connector -1- from the All-Wheel Drive Pump -V415- -2-.
-- Remove the four bolts that connect the All-Wheel Drive Pump -V415- to the hydraulic control unit using the Hex Ball Socket: T10058 .
-- Carefully remove the All-Wheel Drive Pump -V415- -2-. Pay attention to the adapter -item : Adapter in the hydraulic pump while doing so.
- The adapter could fall out when removing the All-Wheel Drive Pump -V415-.
- Insert the adapter into the recesses in the hydraulic pump before installing the All-Wheel Drive Pump -V415-.