All-Wheel Drive Clutch Valve -N445- OR All-Wheel Drive Clutch Valve 2 -N446-, REMOVING AND INSTALLING, 0BE AND 0BX: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- The ball -5-, the guide -4- (the smaller diameter faces the spring) and the spring -3- must be installed in the housing opening -6- for the Clutch Valve -- -2-.
-- Coat the O-rings with ATF and install the new Clutch Valve -- with the new O-rings -arrows-.
-- Tighten the bolts -1- evenly until stop by hand. Then tighten to the tightening specification -item : Bolt.
Further installation is performed in reverse order of the removal. Note the following.
Allocation of the connectors for the Oil Pressure/Temperature Sensor -- and Clutch Valves -- :
- -1- = Oil Pressure/Temperature Sensor 2 -G640- Connector
- -2- = Oil Pressure/Temperature Sensor -G437- Connector
- -3- = All-Wheel Drive Clutch Valve 2 -N446- Connector
- -4- = All-Wheel Drive Clutch Valve -N445- Connector
-- Attach the wiring harness bracket to the rear final drive. Refer to the appropriate Service Information .
-- Fill the ATF in the rear final drive. Refer to ATF, FILLING, 0D3 AND 0BX "quattro sport" .
-- Install the rear section of the exhaust system on the body and align it so it is free of tension. Refer to the appropriate Exhaust Information .