All-Wheel Drive Clutch Actuator 2 -V623-, REMOVING AND INSTALLING, 0B0 "quattro ultra", 09R "quattro ultra"

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the connector from the All-Wheel Drive Clutch Actuator 2 -- -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and then remove the Clutch Actuator -- -1-.

Courtesy of AUDI OF AMERICA, LLC

-- At the same time, guide the plunger of the Clutch Actuator -- -arrow B- out of the locking latch groove -arrow A-.

Courtesy of AUDI OF AMERICA, LLC

Installing

-- Check the correct seating of the seal -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Pull the locking latch -1- out slightly and keep it in this position.

-- Now guide the plunger of the Clutch Actuator -- -arrow B- into the locking latch groove -arrow A-.

-- Insert the Clutch Actuator -- -1- and tighten the bolts -arrows-. Tightening specification -item : Bolt.

Courtesy of AUDI OF AMERICA, LLC

-- Attach the connector -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Check the fluid level. Refer to GEAR OIL LEVEL, CHECKING, 0B0 "quattro ultra" .