Control Module, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- All wheel drive clutch is installed.
- The ignition is off.
- Pay attention to the general repair information. Refer to REPAIR INFORMATION .
A6 TFSIe
-- Position the Engine and Gearbox Jack: VAS 6931 with the Engine/Gearbox Jack - Gearbox Support: T10337 under the tunnel brace and loosen the bolts -1-.
-- Slightly lower the rear transmission.
Continuation for All
-- Remove the bolts -arrows- and remove the driveshaft heat shield -1- (if equipped).
-- If equipped, remove the bolts -1- and remove the heat shield -2-.
-- Remove the connector -3- from the All-Wheel Drive Control Module -- -4-.
-- Unclip the cable on the all-wheel drive clutch -arrow- and move it to the side.
-- Remove the bolts -arrows-.
-- Remove the all-wheel drive Control Module -- from the all-wheel drive clutch and set it slightly at an angle and remove downward.