All-Wheel Drive Clutch Output Shaft Seal, Replacing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- All wheel drive clutch is installed.
- The ignition is off.
- Pay attention to the general repair information. Refer to REPAIR INFORMATION .
-- Remove the driveshaft. Refer to DRIVESHAFT, REMOVING AND INSTALLING .
-- Draining the ATF for the all-wheel drive clutch. Refer to ALL-WHEEL DRIVE CLUTCH OIL, DRAINING AND FILLING .
-- Pry off the dust ring -1-.
- The dust ring cannot be removed without destroying it.
-- Pry out the seal -1- for the all-wheel drive clutch output shaft using the Puller - Crankshaft/Power Steering Seal: T20143/2 .