After-Run Coolant Pump -V51-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2022 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the tower brace. Refer to TOWER BRACE, REMOVING AND INSTALLING .

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the left subframe shield upper section. Refer to SUBFRAME SHIELD, REMOVING AND INSTALLING .

-- Remove the right drive axle heat shield. Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .

-- Remove the right drive axle from the transmission. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Remove the connector -arrow- for the Oxygen Sensor 1 After Catalytic Converter -GX7- from the bracket.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Charge Air Pressure Actuator -V465- -1- from the bracket.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- and remove the bracket -2- upward.

-- Lift the clamp -arrow- and remove the coolant hose.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -3- and free up the wiring harness.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the double bolts -2- and bolts -1- and remove the bracket.

-- Remove the hose clamps -arrows- and remove the After-Run Coolant Pump -V51- with bracket.