Longitudinal Member Coolant Pipe, Right, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Replace the O-ring after removing.
Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.

-- Coat the new O-ring with coolant.

-- If removed, install the parking/auxiliary heater. Refer to the appropriate service information .

-- Install the tower brace. Refer to TOWER BRACE, REMOVING AND INSTALLING .

-- Install the charge air cooler. Refer to CHARGE AIR COOLER, REMOVING AND INSTALLING .

-- Connect the coolant hose to the connector coupling. Refer to Figure.

-- Check the coolant level. Refer to Coolant Level, Checking .