LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> S7 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Sunroof) >> 60 Sunroof >> Water Drain Hoses >> Water Drain Hoses, Removing And Installing >> Front Water Drain Hoses, Removing And Installing >> Removing

Front Water Drain Hoses, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front interior lamp/reading lamp. Refer to CONTROLS .

-- Remove the sun visor. Refer to EXTRA EQUIPMENT .

-- Remove the sun visor center support. Refer to EXTRA EQUIPMENT .

Versions with Driver Assistance Systems Front Camera:

GWWA68-10825Courtesy of AUDI OF AMERICA, LLC

-- To unclip the cover -arrows A, B and C-, insert the Angled Screwdriver: VAS 6416  carefully between the windshield and the cover.

-- Repeat the procedure on the opposite side.

-- Disengage the front of the cover -1- and remove it toward the rear.

Continuation: 

-- Remove the A-pillar trim panel. Refer to VEHICLE INTERIOR TRIM PANELS .

-- Remove the front roof grab handle. Refer to EXTRA EQUIPMENT .

-- Remove the B-pillar upper trim panel. Refer to VEHICLE INTERIOR TRIM PANELS .

-- Open the sun shade.

-- To avoid dirtying the headliner, clean the Removal Wedge: T40233  .

-- Push the Removal Wedge: T40233  between the sunroof frame -1- and the headliner.

GWWA70-12381Courtesy of AUDI OF AMERICA, LLC

-- Using the Removal Wedge: T40233  , loosen the front of the headliner from the sunroof frame -arrows-.

-- Lower the headliner on the corresponding side.

-- Remove the water drain hose from the sliding sunroof and free it up at the clips and guides.

-- Remove the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

GWWA60-10599Courtesy of AUDI OF AMERICA, LLC

-- For guiding the new water drain hose in later, insert an approximately 500 mm long wire through the grommet -arrow- into the water drain hose.

-- Loosen the grommet on the plenum chamber and remove it from the water drain hose.

-- Remove the water drain hose toward the inside while holding the wire at the same time.