Glass Panel Seal, Removing And Installing, Front: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- The vehicle and the seal must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
- Do not stretch the seal when installing it.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution: D 009 401 04 and let dry.
-- Apply Bonding Agent: D 355 205 A2 -item 1- on the painted side of the adhesive surface -2- using the Applicator: D 009 500 25 -item 3- and let it dry for ten minutes.
- If the Bonding Agent: D 355 205 A2 dries longer than two hours, then it must be primed again.
-- Remove the protective film from the adhesive surface.
-- Apply the seals in the opening on the glass panel.