Glass Panel, Removing And Installing, Rear: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Remove any locking fluid residue from the threaded hole using a thread tap.
-- When inserting and sliding into the roof opening, the rain water drain channel -1- must be slid under the seal -2- using the Wedge Set - 1: T10383/1
-- Install the rear glass panel bolts, but do not tighten.
-- Adjust the rear glass panel (Refer to GLASS PANEL, ADJUSTING ), then tighten the bolts.
-- Perform an adaptation. Refer to Sunroof Motor -V1-, PROGRAMMING .