Electronic Steering Column Lock Control Module -J764-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
-- If the Electronic Steering Column Lock Control Module -J764- is replaced, then select the "Control Module, Replacing" program. Refer to DIAGNOSTIC ENTRIES .
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
-- Remove the steering column from the instrument panel crossmember and place in the driver footwell with the steering intermediate shaft attached. Refer to STEERING COLUMN, REMOVING AND INSTALLING .
-- Switch the ignition on.
-- Remove the bolts -2-.
-- Push the tab -1- in the -direction of the arrow-. Remove the Electronic Steering Column Lock Control Module - J764- -2-.
-- Disconnect the connector from the Electronic Steering Column Lock Control Module - J764-.