Overview - Rear Axle Steering
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- Tightening specification List Item: Nut .
- Eccentric Washer
- Tie Rod
- Removing and Installing. Refer to TIE ROD, REMOVING AND INSTALLING .
- If the tie rod is deformed, the rear axle steering gear must always be replaced as well.
- Bolt
- Replace after removing
- Rear Axle Steering Gear
- With integrated Rear Axle Steering Control Module -J1019-
- The Rear Axle Steering Control Module -J1019- cannot be replaced separately, if faulty replace the rear axle.
- Removing and Installing. Refer to REAR AXLE STEERING GEAR, REMOVING AND INSTALLING .
- Aligning. Refer to REAR AXLE STEERING GEAR, ALIGNING .
- In vehicles without rear axle steering, a steering adapter will be installed instead Refer to Fig 2.
- Subframe
- Bolt
- Replace after removing
- 90 Nm + 180°
- Heat Shield
- Bolt
- 9 Nm