Wheel Bearing Unit, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicles with active suspension: pay attention to the safety precautions. Refer to SAFETY PRECAUTIONS WHEN WORKING ON VEHICLES WITH ACTIVE SUSPENSION .
-- Loosen the connection between the drive axle and wheel hub. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
-- Remove the brake rotor. Refer to BRAKE ROTOR, REMOVING AND INSTALLING .
-- Remove the wind deflector for the lower rear transverse link. Refer to WIND DEFLECTOR, REMOVING AND INSTALLING .
-- Remove the bolts -arrows- and remove the wheel bearing unit from the drive axle and the wheel bearing housing.
- Handling the wheel bearing. Refer to Figure.