Sway Stabilization Control Module 2 -J1096-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
-- If the Sway Stabilization Control Module 2 -J1096- is replaced, select the "Control module, replacing" program. Refer to DIAGNOSTIC ENTRIES .
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
-- Vehicles with rear axle steering; remove the rear axle steering gear. Refer to REAR AXLE STEERING GEAR, REMOVING AND INSTALLING .
-- Remove the nuts -arrows- and then remove the heat shield -1-.
-- De-energize the 48 Volt system. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Disconnect the connectors -2 and 3- and free up the wires.
-- Remove the bolts -arrows- and remove the Sway Stabilization Control Module 2 -J1096- -item 1-.