Overview - Stabilizer Bar, Without Sway Stabilization
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Replace after removing
- 25 Nm + 90°
- Stabilizer Bar
- With rubber bushing and clamp
- The rubber bushing and clamp cannot be replaced individually
- Removing and Installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING, WITHOUT SWAY STABILIZATION .
- Subframe
- Nut
- Replace after removing
- Front Upper Transverse Link
- Bolt
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .
- 40 Nm + 180°
- Coupling Rod
- Removing and Installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .
- 40 Nm + 180°
- Nut
- Replace after removing